Seeing a big puddle of water coming from your washer can be disconcerting, and the first thing that you think of is your wallet getting smaller. Well if you are looking for a guide on how to fix a leaky washing machine, then you’re in luck. In this article I will explain how to go about diagnosing and repairing your leaky washer without going through a repairman. But first here’s a note: remember to unplug your washing machine before you start any repairs. Otherwise you can risk serious damage to yourself and your appliance.
Alright, so here’s the first tip on how to fix a leaky washing machine lg washer repair pasadena: find the source of the leak. This is pretty self-explanatory. Empty the washer of any water that might be left over. Then put a dry beach towel underneath the machine, run the washer through a cycle with no clothes in it. Watch the towel for any wet spots that appear, also watch the drain hoses for any water beads or leaks. Leaks can come from more than one source so you should watch your machine until you are sure where it is leaking. Once you have figured that out it is time to figure out how to fix it of course.
Alright, step one is to check your hoses for leaks. This is the most common and most easily repairable of leaky washer problems. If you noticed water beading or dripping from the hoses during its test cycle then your problem is coming from your hoses. You can either cut right to the chase and replace your hoses with new ones, or you could replace the rubber washers on the inside of the hose and use Teflon tape to repair any holes or cracks. However, if you choose to tape up the hoses and you still notice leaking you should just replace them. If you are still unsure of where the leak is coming from you can move on to step two.
The next step of how to fix a leaky washing machine: check the washer pump for leaks. Now there are two different types of washers: belt-drive and direct drive. You’ll need to figure out which one yours is, and to do that you need to open up your washer’s cabinet. If you don’t see any belts then yours is direct drive, and if you do – yours is obviously a belt-drive. If you have a direct drive the fix is easy, just unscrew the pump and install the new one. If you have a belt drive the fix is a little more complicated. You will need to replace the whole assembly. Instructions can be found online, but it might be a wise idea to call a repairman out to replace it (unless you are a pretty handy do-it-yourselfer.)
If either of those repairs do not help your leaky washer problem then it could be the hoses inside of your machine, or leaky tub fittings. If you haven’t done those repairs yourself, or if you are still not completely sure where the water is leaking from then your best bet would be to call a repairman to help fix your leaky washing machine. Good luck!